Quiver Killer DIY Installation Kit


£27.00 (inc VAT)
The Quiver Killer DIY installation tool set is ideal for the installation of QK binding inserts without using a mounting jig.

Trade installers or DIY'ers using a jig or doing high volume installations are recommended to use the Pro Installation Kit.

The DIY set comprises of the following:

- Quiver Killer step drill bit (always pilot drill first*)
- Quiver Killer tap 
- M5 pan head machine screw with locking nuts for installing the inserts
- sachet of Vibra-Tite VC3 thread lock (for one set of screws)
- sachet of two part slow cure epoxy c/w mixing palette & mixing stick (for one set of inserts)

Additional VC3 threadlock sachets &/or epoxy sachets can be purchased seperately. 

* For best results pilot drill with a proper binding mounting step drill which are availalbe in the 'Binding Mounting Tools' section. And also check out Jon's Drill'n'Tap Guide. 

Loctite may be harmful to some of the plastics of which bindings are composed. For example, 22 Designs specifically forbids the use of Loctite with their telemark bindings. 

For this reason Quiver Killer only recommend the use Vibra-Tite VC3
 which is a non-anaerobic formula that is benign to all plastics. Paint the solution onto the end 3/4mm of the mounting screws & leave to dry before installation. The screws may be un- and re-installed several times without reapplication.   

WhitedotscottKinkovistDynafitQuiver killerPM GearColltex zardoz wax